Netgear XSM4348CS CLI Manual Software Version 12.x - Page 35

M4300 Intelligent Edge Series Fully Managed Stackable Switches Note: In the previous example for model M4300-96X, a third-party HDMI port card is shown in slot 1/5. You can insert a third-party HDMI port card in any of the upper slots (1-6), but not in the lower slots. If you preconfigure a slot for a particular type of port card, install only that type of port card in the slot. In the previous example for model M4300-96X, if you insert a port card other than the APM408P in slot 1/8, the slot is not activated, the interfaces on the port card do no become operational, and the switch generates a log message about a mismatch in the configured port card and the inserted port card in the memory log. Therefore, if you preconfigure a slot for a particular type of port card, insert only that type of port card in the slot. You can change the configuration for a slot from a set type of port card to a dynamic port card by entering the no slot unit/slot command. For example, to remove the configuration of slot 2 so that the slot can enter any of the supported port cards dynamically, enter the no slot 1/2 command. Note: The output of the show slot command shows only the port cards in the slots that are populated or are configured for a particular type of port card. If you supply a value for unit/slot, the following additional information displays: Term Inserted Card Model Identifier Inserted Card Description Configured Card Description Definition The model identifier of the card inserted in the slot. The model identifier is a 32-character field used to identify a card. This field is displayed only if the slot is populated. The card description. This field is displayed only if the slot is populated. The card description of the card preconfigured in the slot. show stack-status Use this command to display the stack unit's received heartbeat message timings and the dropped or lost statistics for the specified unit. Use the following optional keywords to specify the command output: • number. The output displays for a specific unit in the stack. The value for number can be from 1 to 8. • all. The output displays for all units in the stack. Use the optional keyword clear to remove the statistics of the stack heartbeat message. Stacking Commands 35 CLI Command Reference Manual