Netgear XSM4348CS CLI Manual Software Version 12.x - Page 83
permit priority, deny ip-source, deny service
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Parameter service priority Definition Indicates the service type: telnet, ssh, http, https, or snmp. The priority for the rule. permit priority This command assigns a permit priority to the rule. Each rule requires a unique priority. Use this command in Management access-list configuration mode. Format Mode permit priority priority Management access-list configuration deny ip-source This command sets deny conditions for the management access list based on the source IP address of a packet. Optionally, you can specify a subnet mask, service type, priority, or a combination of these for the rule. Each rule requires a unique priority. Use this command in Management access-list configuration mode. Format Mode deny ip-source ip-address [mask {mask | prefix-length}] [service service] [priority priority] Management access-list configuration Parameter ip-address mask prefix-length service priority Definition The source IP address. The network mask of the source IP address. Specifies the number of bits that comprise the source IP address prefix. The prefix length must be preceded by a forward slash (/). Indicates the service type: telnet, ssh, http, https, or snmp. The priority for the rule. deny service This command sets deny conditions for the management access list based on the access protocol. Each rule requires a unique priority. Use this command in Management access-list configuration mode. Format Mode deny service service [priority priority] Management access-list configuration Management Commands 83 CLI Command Reference Manual