Netgear XSM4348CS CLI Manual Software Version 12.x - Page 1070

M4300 Intelligent Edge Series Fully Managed Stackable Switches If no interface is specified, the command displays the status parameters for all PIM-enabled interfaces. Format Modes show ipv6 pim interface [unit/slot/port | vlan vland-id] Privileged EXEC User EXEC Term Definition Interface unit/slot/port Mode Indicates whether the PIM mode enabled on the interface is dense or sparse. Hello Interval The frequency at which PIM hello messages are transmitted on this interface. By default, the value is 30 seconds. Join Prune Interval The join/prune interval for the PIM router. The interval is in seconds. DR Priority The priority of the Designated Router configured on the interface. This field is not applicable if the interface mode is Dense BSR Border Identifies whether this interface is configured as a bootstrap router border interface. Neighbor Count The number of PIM neighbors learned on this interface. This is a dynamic value and is shown only when a PIM interface is operational. Designated Router The IP address of the elected Designated Router for this interface. This is a dynamic value and will only be shown when a PIM interface is operational. This field is not applicable if the interface mode is Dense Command example: (NETGEAR) #show ipv6 pim interface Interface 1/0/1 Mode Sparse Hello Interval (secs 30 Join Prune Interval (secs 60 DR Priority 1 BSR Border Disabled Neighbor Count 1 Designated Router 192.168.10.1 Interface 1/0/2 Mode Sparse Hello Interval (secs 30 Join Prune Interval (secs 60 DR Priority 1 BSR Border Disabled Neighbor Count 1 Designated Router 192.168.10.1 IPv6 Multicast Commands 1070 CLI Command Reference Manual