Panasonic HPX500 Operating Instructions - Page 142
Warning System, Warning Description Tables
UPC - 791871302965
View all Panasonic HPX500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
Chapter 9 Maintenance and Inspections Warning System Warning Description Tables If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the WARNING lamp, lamps inside the viewfinder and a warning tone. Priority Warning type LCD or viewfinder indication Viewfinder LED (except tally) Tally lamp Warning lamp Alarm tone *6 Warning description and recording/ playback operation Countermeasures 1 System error SYSTEM ERROR Cause indication *1 Red blinking No Blinks 4 times per second Blinks 4 times per second Continuous tone P2 microprocessor or control failure. Operation stops. Check the cause indication *1 and consult your distributor. A P2 card was Incorrect TURN POWER 2 P2 card OFF removal Blinks red No Blinks 4 times per second Blinks 4 times per second removed during Continuous access and card data tone was corrupted. All four access LEDs Turn off the power. Repair the P2 card if the clips on the card are corrupted. LOW BATTERY blink orange (4 Hz) Red blinking, and the battery level 3 The battery is exhauseted bar blinks with the empty status. (This indication appears also when MENU indications have No Blinks 1 time per second Lights The battery is exhausted. Continuous tone Recording and playback stop. The camera stops automatically when the voltage drops. Replace the battery. been turned OFF.) 4 When SAVE P2 card fully recorded P2 FULL LED is set to Blinks red P2CARD, the (appears only for SAVE LED 3 seconds in MCR blinks 4 times mode.) per second. Blinks 4 times per second after completion of Lights after completing recording Continuous tone after completing recording No more space on P2 cards left for recording.Stop recording. *3 recording. Delete clips that are no longer needed or insert a new card. Turn the power off and then back on 5 Recording error REC WARNING Cause indication *2 Blinks red No Blinks 4 times per second Blinks 4 times per second Intermittent tone 4 times per second A recording error has occurred. Stop recording. *4 again and check recording and playback. Replace any P2 card that does not enable normal recording. Check camera and Blinks 4 Blinks 4 external device 1394 1394INTIAL times per times per Incorrect 1394 connections and 6 connection ERROR errors Blinks red No second second No connection or signal reconnect as during during input/output error. necessary. Then turn recording. recording. the power off and The 1394 cable back on again. PC mode 1394 7 HOST No connection error No Blinks 4 Blinks 4 times per times per second second No has become disconnected or multiple devices are connected. (Normal PC mode operation is Connect a hard disk drive according to supplied operating instructions. possible.) 142 Warning System