Dell PowerConnect 5548 User Guide - Page 182
Defining SNTP Servers Settings Using CLI Commands, Link Local Interface, ISATAP, SNTP Server
View all Dell PowerConnect 5548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
- Link Local Interface - When the server supports an IPv6 Link Local address, this specifies the Link Local interface. Select one of the possible options: • VLAN - The VLAN on which the IPv6 interface is configured. • ISATAP - The IPv6 interface is configured on an ISATAP tunnel. - SNTP Server - Enter the SNTP server's IP address. - Poll Interval - Enable/disable polling the selected SNTP server for system time information, when enabled. - Encryption Key ID - Check to use an encryption key, and select one of the encryption keys that was defined in the SNTP Authentication pages. Defining SNTP Servers Settings Using CLI Commands The following table summarizes the CLI commands for setting fields displayed in the SNTP Server pages. Table 9-10. SNTP Server CLI Commands CLI Command sntp server {ipv4address|ipv6-address|ipv6address|hostname} [poll] [key key-id] no sntp server {ipv4address|ipv6-address|ipv6address|hostname} sntp unicast client poll no sntp unicast client poll show sntp status Description Configures the device to use SNTP to request and accept SNTP traffic from a server. Use the no form of this command to remove a server from the list of SNTP servers. Enables polling for the SNTP predefined Unicast clients. Use the no form of this command to disable the polling for the SNTP client. Displays the SNTP server statuses. 182 Dell PowerConnect 55xx Systems User Guide