Dell PowerConnect 5548 User Guide - Page 375
Configuring sFlow Interfaces Using the CLI Commands, Flow Sampling Maximum Header Size 20-256
View all Dell PowerConnect 5548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 375 highlights
- Flow Sampling Average Sampling Rate(1024-1073741823) - If x is entered, a flow sample will be taken for each x frames. - Flow Sampling Receiver Index - Select one of the indices that was defined in the sFlow Receivers Settings pages. - Flow Sampling Maximum Header Size (20-256) - Maximum number of bytes that should be copied from a sampled packet. - Counters Sampling - Enable/disable counters sampling. Flow sampling cannot be disabled if Flow Sampling is disabled - Counters Sampling Interval (15-86400) - If x is entered, this specifies that a counter sample will be taken for each x seconds. - Counters Sampling Receiver Index - Select one of the indices that was defined in the sFlow Receivers Settings pages. Configuring sFlow Interfaces Using the CLI Commands The following table summarizes the CLI commands for configuring sFlow interfaces. Table 9-74. sflow Interface CLI Commands CLI Command Description sflow flow-sampling rate receiver-index [max-header-size bytes] no sflow flow-sampling Enables sFlow Flow sampling and configure the average sampling rate of a specific port. Use the no form of this command to disable Flow sampling. sflow counters-sampling interval receiver-index no sflow counters-sampling Enable sFlow counters sampling and to configure the maximum interval of a specific port. Use the no form of this command to disable sFlow Counters sampling. The following is an example of the CLI commands: console(config)# interface gi2/0/3 console(config-if)#sflow flow-sampling 1024 1 Dell PowerConnect 55xx Systems User Guide 375