Dell PowerConnect 5548 User Guide - Page 226
Table 9-30., ISATAP Tunnel CLI Script, CLI Command, Description, ISATAP Tunnel CLI Commands Continued
View all Dell PowerConnect 5548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 226 highlights
Table 9-29. ISATAP Tunnel CLI Commands (Continued) CLI Command Description tunnel isatap query-interval seconds no tunnel isatap query-interval Configures the interval between DNS Queries (before the IP address of the ISATAP router is known) for the automatic tunnel router domain name. Use the no form of this command to restore the default configuration. tunnel isatap solicitationinterval seconds no tunnel isatap solicitationinterval Configures the interval between ISATAP router solicitations messages (when there is no active ISATAP router). Use the no form of this command to restore the default configuration. tunnel isatap robustness number Configures the number of DNS no tunnel isatap robustness Query/Router Solicitation refresh messages that the device sends. Use the no form of this command to restore the default configuration. show ipv6 tunnel Displays information on the ISATAP tunnel. The following is an example of a CLI script to create a tunnel: Table 9-30. ISATAP Tunnel CLI Script CLI Command Description console#config Enter Global Configuration mode. console(config)# interface vlan 1 Enter Interface mode for VLAN 1. console(config-if)# ip address 10.5.225.40 /27 Configure an IP address with prefix length of 27. console(config-if)# ip default-gateway Set the address of the default 10.5.225.33 gateway and exit Interface console(config-if)#exit mode. 226 Dell PowerConnect 55xx Systems User Guide