Dell PowerConnect 5548 User Guide - Page 206
Table 9-19., Sample CLI Script to Con IPv4 Statically on a VLAN, CLI Command, Description
View all Dell PowerConnect 5548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 206 highlights
The following are sample procedures to configure a static IPv4 address on an interface using CLI and then to remove it: Table 9-19. Sample CLI Script to Configure IPv4 Statically on a VLAN CLI Command console#config console(config)# interface vlan 1 console(config-if)# ip address 10.5.225.40 /27 console(config-if)# ip defaultgateway 10.5.225.33 console(config-if)# no ip address Description Enter Global Configuration mode. Enter Interface mode for VLAN 1. Set the routing interface with prefix length of 27. Set the address of the default gateway Remove the address (if required). Table 9-20. Sample CLI Script to Configure IPv4 Statically on a Port CLI Command console#config console(config)# interface gi1/0/1 console(config)# no switchport console(config-if)# ip address 10.5.225.40 /27 console(config-if)# ip defaultgateway 10.5.225.33 console(config-if)# no ip address Description Enter Global Configuration mode. Enter Interface mode for port 1 on unit 1. Enable the port to work as an IP interface (Layer 3 mode). Configure an IP address with prefix length of 27. Set the address of the default gateway Remove the address (if required). 206 Dell PowerConnect 55xx Systems User Guide