Dell PowerConnect 5548 User Guide - Page 372

- IPv6 Address Type - When the server supports IPv6, this specifies the type of static address supported. The possible options are: • Link Local - A Link Local address that is non-routable and used for communication on the same network only. • Global - A globally unique IPv6 address; visible and reachable from different subnets. - Link Local Interface - When the server supports an IPv6 Link Local address, this specifies the Link Local interface. The possible options are: • None - Disable the ISATAP tunnel. • ISATAP - The IPv6 interface is configured on an ISATAP tunnel. - IP Address - Enter the receiver's IP address. 4 Enter the fields: - Syslog Port Number - Port to which SYSLOG message are sent. - Maximum Header Size (Bytes) - Maximum number of bytes that can be sent to the receiver in a single sample datagram (frame). Adding an sFlow Receiver Using the CLI Commands The following table summarizes the CLI commands for adding an sFlow receiver. Table 9-73. sflow Receiver CLI Commands CLI Command sflow receiver index {ipv4address|ipv6-address|hostname} [port port] [max-datagram-size bytes] no sflow receiver index show sflow configuration [port_id] Description Defines an sFlow receiver. Use the no form of this command to remove the definition of the receiver. Displays the sFlow configuration for ports that are enabled for Flow sampling or Counters sampling. 372 Dell PowerConnect 55xx Systems User Guide