Dell PowerConnect 5548 User Guide - Page 515

Managing Bridge Multicast Groups Using CLI Commands The following table summarizes the CLI commands for managing Multicast service members as displayed in the Bridge Multicast Group pages. Table 16-3. Bridge Multicast Group CLI Commands CLI Command Description bridge multicast address {macmulticast-address|ip-multicastaddress} Registers MAC-layer Multicast addresses to the bridge table, and adds static ports to the group. no bridge multicast filtering Use the no form of this command to disable Multicast address filtering. bridge multicast forbidden address {mac-multicastaddress|ip-multicastaddress}[add|remove] Forbids adding a specific Multicast address to specific ports. Use the no form of this command to return to default {[gigabitethernet|tengigabitethe Use the no form of this command to rnet] interface-list|port- restore the default configuration. channel LAG-number-list} no bridge multicast forbidden address {mac-multicast-address} show bridge multicast addresstable [vlan vlan-id] [address {mac-multicast-address|ipmulticast-address}] [format ip|mac] Displays Multicast MAC address table information. The following is an example of the CLI commands: console(config-if)# bridge multicast address 0100.5e02.0203 add gi1/0/11,gi1/0/12 console(config-if)# end console # show bridge multicast address-table VLAN ---1 MAC Address ----------0100.5e02.0203 Type ----static Forbidden ports for multicast addresses: Ports ---------- gi1/0/11, gigi1/0/12 Dell PowerConnect 55xx Systems User Guide 515