Dell PowerConnect 5548 User Guide - Page 64

Using the CLI This section provides some general information for using the CLI. For a complete description of CLI commands, refer to the Dell PowerConnect 55xx Systems CLI Reference Guide. Command Mode Overview The CLI is divided into command modes, each with a specific command set. Entering a question mark at the terminal prompt displays a list of commands available for that particular command mode. In each mode, a specific command is used to navigate from one mode to another. These modes are described below. User EXEC Mode During CLI session initialization, the CLI is in User EXEC mode. Only a limited subset of commands is available in User EXEC mode. This level is reserved for tasks that do not change the terminal configuration and is used to access configuration sub-systems. After logging into the device, User EXEC command mode is enabled. The user-level prompt consists of the host name followed by the angle bracket (>). For example: console> NOTE: The default host name is console unless it has been modified during initial configuration. The User EXEC commands enable connecting to remote devices, changing terminal settings on a temporary basis, performing basic tests, and listing system information. To list the User EXEC commands, enter a question mark at the command prompt. To enter the next level, Privileged EXEC mode, a password is required (if configured). Privileged EXEC Mode Privileged EXEC mode provides access to the device global configuration. 64 Dell PowerConnect 55xx Systems User Guide