Dell PowerConnect 5548 User Guide - Page 58
Configuring the Stack, Configuration Using the Setup Wizard - default password
View all Dell PowerConnect 5548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Configuring the Stack The switch is always considered to be a stack of switches even if the stack only contains a single switch. If there is more than one switch in the stack, each switch must be configured individually. See "Assigning Unit IDs" on page 48 for instructions on how to configure the stack. Configuration Using the Setup Wizard The Setup Wizard guides you through the initial switch configuration to get the system up and running as quickly as possible. Note that you can skip the Setup Wizard and configure the switch manually through the CLI. The Setup Wizard configures the following fields: • SNMP Community String and SNMP Management System IP address (optional) • Username and password • Management switch IP address • IP subnet mask • Default gateway IP address NOTE: The Setup Wizard assumes the following: • The PowerConnect switch was never configured before and is in the same state as when you received it. • The PowerConnect switch booted successfully. • The console connection is established and the console prompt is displayed on the screen of a VT100 terminal switch. Connect the Master unit to a terminal. You can identify the Master unit by the illuminated Master LED on the front panel of the switch (see Figure 5-2). To configure the system using the Setup Wizard: 1 Obtain the following information from the network administrator: • SNMP Community String and SNMP Management System IP address (optional) • Username and password 58 Dell PowerConnect 55xx Systems User Guide