Dell PowerConnect 5548 User Guide - Page 229
Incomplete, Reachable, Stale, Delay, Probe, Static Only, Dynamic Only, All Dynamic and Static
View all Dell PowerConnect 5548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 229 highlights
The previously-defined neighbors are displayed along with their states. The possible states are: - Incomplete - An address resolution is in progress, and the link-layer address of the neighbor has not yet been determined. - Reachable - The neighbor is known to have been reachable recently (within tens of seconds). - Stale - The neighbor is no longer known to be reachable, but until traffic is sent to the neighbor, no attempt is made to verify its reachability. - Delay - The neighbor is no longer known to be reachable, and traffic has recently been sent to the neighbor. Rather than probe the neighbor immediately, however, there is a delay sending probes for a short while, in order to give upper-layer protocols a chance to provide reachability confirmation. - Probe - The neighbor is no longer known to be reachable, and Unicast Neighbor Solicitation probes are being sent to verify reachability. 2 To clear the Neighbors table, select one of the following options: - None - Does not clear any entries. - Static Only - Clears the static entries. - Dynamic Only - Clears the dynamic entries. - All Dynamic and Static - Clears the static and dynamic address entries. 3 To add a new IPv6 neighbor, click Add, and enter the fields: - IPv6 Interface - Displays the interface on which IPv6 Interface is defined. - IPv6 Address - Enter the neighbor IPv6 address. - MAC Address - Enter the MAC address assigned to the interface. Dell PowerConnect 55xx Systems User Guide 229