Dell PowerConnect 5548 User Guide - Page 219

The following is a sample script to configure IPv6 using CLI: Table 9-27. Sample CLI Script to Configure IPv6 on a Port CLI Command console#config console(config)# interface vlan 1 console(config-if)# ipv6 enable console(config-if)# ipv6 address 5::1/64 Description Enter Global Configuration mode. Enter VLAN mode for VLAN 1. Enable IPv6 (dynamic). Set the IPv6 address (static) IPv6 Default Gateway Use the IPv6 Default Gateway pages to configure and view the default IPv6 router addresses. This list contains routers that are candidates to become the switch default router for non-local traffic. The switch randomly selects a router from the list. The switch supports one static IPv6 default router. Dynamic default routers are routers that have sent router advertisements to the switch IPv6 interface. When adding or deleting IP addresses, the following events occur: • When removing an IP interface, all of its default gateway IP addresses are removed. • Dynamic IP addresses cannot be removed. • An alert message is displayed after a user attempts to insert more than one IP address. • An alert message is displayed when attempting to insert a non-Link Local type address. Dell PowerConnect 55xx Systems User Guide 219