Epson 7850p User Manual - Page 29

Shutting Down the Projector When you've finished using the projector, follow the recommended procedure to shut it down. This extends the life of the lamp and protects the projector from possible overheating. 1. Turn off any equipment plugged into the projector. 2. To turn off the projector, press the red PPower button on the projector or remote control. Power button note When the projector has not received any input signals for 30 minutes, it automatically turns off the projector lamp and enters "sleep mode." This conserves electricity, cools the projector, and extends the life of the lamp. If you want to start projecting again, press the Power button. If you are done using the projector, unplug the power cord. To turn off sleep mode, see page 139. You see a confirmation message. (If you don't want to turn it off, press any other button.) 3. Press the Power button again. The power light flashes orange for about 40 seconds as the projector cools down. After the projector has cooled, the orange light stays on and the exhaust fan shuts off. If you want to turn the projector on again, wait until the orange light stops flashing. Then press the Power button. 4. If you extended the adjustable front foot, press up on the blue foot release lever to retract it. 5. Replace the lens cap and unplug the power cord. 6. If you're using a remote control, set its ON/OFF switch to OFF. Power OFF? Yes : Press button No : Press any other button caution To avoid damaging the projector or lamp, never unplug the power cord when the power light is green or flashing orange. Displaying and Adjusting the Image 29