HP 1050c Service Manual - Page 127

NOTE Service Calibrations 3. Service Station The purpose of this Service Calibration is to calibrate the Service Station in relation to the Carriage Assembly. Perform the Service Station Calibration whenever: n Carriage Assembly is disassembled or replaced. n Platen Assembly is disassembled or replaced. n Service Station is disassembled or replaced. Perform the Service Station Calibration as follows: Make sure you load media bigger than A4 in to the Printer before performing this calibration. Do NOT use any other type of media apart from HP Coated or HP High Gloss Photo Paper. 1 In the Service Calibrations submenu, scroll to "3. Service Station" and press Enter. Service Calibrations 1. Accuracy cal... 2. Line sensor cal... 3. Service station... 4. Roller mark position... 5. Pen to Paper Spacing... Top Back ↑ Make Selection ↓ Enter Press Enter 2 The following message will appear asking you to confirm the operation. Select ACCEPT if you want to continue the Service Station Calibration, or select CANCEL if you want to cancel the it. Press Enter once the selection has been made. 3. Service Station Accept Cancel Top Back ↑ Make Selection ↓ Enter Press Enter HP DesignJets 1050C and 1055CM Printers Service Manual 5-11