HP 1050c Service Manual - Page 251
For steps 3 and 4, refer to Cutter Assembly, For the following steps, refer
View all HP 1050c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
NOTE Removal and Installation For steps 3 and 4, refer to Figure 39 3. Loosen the retaining screw T-9 at the back of the printhead tube connector. 4. Remove the printhead tube connector (refer to Figure 39). View from the rear c. Loosen this screw a. Push in here Printhead tube connector a. Push in here b. Pull here NOTE Figure 39: Cutter Assembly 5. Move the Printhead tube connector to a safe position. For the following steps, refer to Figure 40. 6. Remove one screw (item 1) and washer (item 2) that attaches the Cutter Assembly (item 3) to the Carriage Assembly (item 4). 7. Slide the Cutter Assembly (item 3) towards you and remove from the Printer. 4 1 2 3 Figure 40: Cutter Assembly C607417a HP DesignJets 1050C and 1055CM Printers Service Manual 8-43