Intel S2600GZ S2600GZ/GL - Page 187

BIOS Setup Utility Intel® Server Board S2600GZ/GL TPS 4. Reset on ERR2 Option Values: Enabled Disabled Help Text: When enabled system gets reset upon encountering ERR2 (Fatal error); when disabled system does not get reset on ERR2 Comments: This option controls whether the system will be reset if the BMC's ERR2 Monitor times out, that is, the ERR2 signal has been continuously asserted long enough to indicate that the SMI Handler is not able to service the condition Note: If "Reset on ERR2" is Disabled, this can result in a system hang for certain error conditions, possibly with the system unable to update the System Status LED or log an error to the SEL before hanging. Back to [Server Management Screen] 5. Resume on AC Power Loss Option Values: Stay Off Last State Power On Help Text: System action to take on AC power loss recovery. [Stay Off] - System stays off. [Last State] - System returns to the same state before the AC power loss. [Power On] - System powers on. Comments: This option controls the policy that the BMC will follow when AC power is restored after an unexpected power outage. The BMC will either hold DC power off or always turn it on to boot the system, depending on this setting - and in the case of Last State, depending on whether the power was on and the system was running before the AC power went off. When this setting is changed in Setup, the new setting will be sent to the BMC. However, the BMC maintains ("owns") this Power Restore Policy setting, and it can be changed independently with an IPMI command to the BMC. BIOS gets this setting from the BMC early in POST, and also for the Setup Server Management screen. Back to [Server Management Screen] 6. Power Restore Delay Option Values: Disabled Auto Fixed Help Text: Allows a delay in powering up after a power failure, to reduce peak power requirements. The delay can be fixed or automatic between 25-300 seconds. 174 Revision 1.1 Intel order number G24881-004