Brother International LZ2-B856E Instruction Manual - English and Spanish - Page 65
Installing the needle, 1. Einsetzen der Nadel, 1. Installation de l'aiguille, 1. Colocación de la
View all Brother International LZ2-B856E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
6. PREPARATION BEFORE SEWING 6. VORBEREITUNGEN ZUM NÄHEN 6. PREPARATIFS AVANT LA COUTURE 6. PREPARATIVOS ANTES DE COSER 6. PREPARATION BEFORE SEWING 6. VORBEREITUNGEN ZUM NÄHEN 6. PREPARATIFS AVANT LA COUTURE 6. PREPARATIVOS ANTES DE COSER 6-1. Installing the needle 6-1. Einsetzen der Nadel 6-1. Installation de l'aiguille 6-1. Colocación de la aguja CAUTION/ACHTUNG/ATTENTION/ATENCION • Turn off the power switch before installing the needle, otherwise the machine may operate if the treadle is pressed by mistake, which could result in injury. • Schalten Sie den Netzschalter vor dem Einsetzen der Nadel aus, weil Verletzungen entstehen können, wenn sich die Maschine durch unbeabsichtigtes Drücken des Pedals in Gang setzt. • Mettre l'interrupteur d'alimentation sur la position d'arrêt avant d'installer l'aiguille, sinon la machine risquera de se mettre en marche si on enfonce accidentellement la pédale, et donc de causer des blessures. • Desconectar el interruptor principal antes de colocar la aguja, de lo contrario la máquina podría comenzar a funcionar si por descuido se pisara el pedal, lo que podría resultar en heridas. Long groove in needle Lange Nut Rainure longue de l'aiguille Ranura larga en la aguja Front vorne Avant Adelante q w e 1. Turn the machine pulley to move the needle bar q to its highest position. 2. Loosen the screw w. 3. Insert the needle e in a straight line as far as it will go, making sure that the long groove on the needle is toward the front, and then securely tighten the screw w. 1. Stellen Sie die Nadelstange q durch Drehen der Nähmaschinenriemenscheibe in die höchste Position. 2. Lösen Sie die Schraube w. 3. Stecken Sie die Nadel e mit der langen Nut nach vorne gerichtet ganz hinein und ziehen Sie die Schraube w fest. 1. Tourner la poulie de machine de manière à amener la barre à aiguille q à sa position la plus haute. 2. Desserrer la vis w. 3. Insérer l'aiguille e en ligne droite bien à fond, en veillant à ce que la rainure longue de l'aiguille soit orientée vers l'avant, puis bien serrer la vis w. 1. Girar la polea de la máquina para levantar la barra de aguja q hasta quede en la posición más alta. 2. Aflojar el tornillo w. 3. Insertar la aguja e en línea recta tanto como sea posible, asegurándose que la ranura larga en la aguja se encuentre hacia adelante, y luego apretar firmemente el tornillo w. LZ2-B855E,B856E 46