Canon imageCLASS MF6595cx imageCLASS MF6500 Series Reference Guide - Page 199

Before Using the Machine 1 Document and Paper 2 Copying 3 Sending and Receiving (MF6595cx/ MF6595/MF6590 Only) 4 Printing and Scanning 5 Network (MF6595cx/MF6595/ 6 MF6590/MF6540 Only) Remote UI (MF6595cx/MF6595/ 7 MF6590/MF6540 Only) System Settings 8 Maintenance 9 Troubleshooting 10 Appendix 11 PLEASE WAIT Description Action This message appears when turning on the main power switch, or when the machine is not ready for printing. Wait until the message disappears. RECEIVED IN MEMORY Description The machine received the fax in memory because paper or toner ran out, paper jams occurred, or incorrect size paper was loaded. Action Load the correct-size paper in the paper cassette, replace the toner cartridge, or clear the paper jams. For more information, see the following: "Setting Paper Type and Size," on p. 2-12 "Replacing the Toner Cartridge," on p. 9-13 "Clearing Jams," on p. 10-3. START AGAIN Description A transmission error occurred because the line condition was poor. Action Check the line condition, then try again. Description The paper jammed or ran out during printing a report. Action Clear the paper jam, or replenish the paper, then try again. Back Previous Next TOP STOP KEY PRESSED PRESS OK KEY Description Action SYSTEM ERROR Description Action TONER IS NOT SET INSERT TONER Description Action [Stop] has been pressed while scanning the document using the ADF. Press [OK], then set the document again. Some kind of error has occurred in the machine. Turn off the main power switch, wait for more than 10 seconds, then turn it on again. If the message persists, unplug the machine from the power supply and contact Canon Customer Care Center. A toner cartridge is not installed or not installed correctly. Install the toner cartridge correctly. Table of Contents Index 10-12