Canon imageCLASS MF6595cx imageCLASS MF6500 Series Reference Guide - Page 216

Before Using the Machine 1 Document and Paper 2 Copying 3 Sending and Receiving (MF6595cx/ MF6595/MF6590 Only) 4 Printing and Scanning 5 Network (MF6595cx/MF6595/ 6 MF6590/MF6540 Only) Remote UI (MF6595cx/MF6595/ 7 MF6590/MF6540 Only) System Settings 8 Maintenance 9 Troubleshooting 10 Appendix 11 Faxes do not print. Q Have you removed the plastic seal from the toner cartridge? A Make sure you remove the seal from the cartridge. (See "Set Up the Machine," in the Starter Guide.) Q Is the toner cartridge installed properly? A Make sure the toner cartridge is installed properly. (See "Set Up the Machine," in the Starter Guide.) Q Is the cartridge out of toner? A Replace the toner cartridge. (See "Replacing the Toner Cartridge," on p. 9-13.) A Select for in in the menu. With this setting, the machine will not store documents in the memory even if the toner has run out. (See "CONT. PRINTING," on p. 11-18.) Back Previous Next TOP Q Is the correct size of paper loaded in the machine? A Make sure you load paper that meets the requirements for use. (See "Paper Requirements," on p. 2-7.) A Change in the menu. (See "REG. PAPER SIZE," on p. 11-8.) Received faxes print blotched or unevenly. Q Are the telephone lines in poor condition, or do you have a bad connection? A Error Correction Mode (ECM) should eliminate such problems. However, if the telephone lines are in poor condition, you may have to try again. Q Is the sender's machine functioning properly? A Ask the sender to check that the scanning components of the machine are clean. Q Is the toner low or unevenly distributed? A Redistribute the toner inside the toner cartridge. If the problem persists, replace the toner cartridge. (See "Replacing the Toner Cartridge," p. 9-13.) Table of Contents Index 10-29