Canon imageCLASS MF6595cx imageCLASS MF6500 Series Reference Guide - Page 215
Set <toner Saver Mode> To <off>. See Common
View all Canon imageCLASS MF6595cx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
Before Using the Machine 1 Document and Paper 2 Copying 3 Sending and Receiving (MF6595cx/ MF6595/MF6590 Only) 4 Printing and Scanning 5 Network (MF6595cx/MF6595/ 6 MF6590/MF6540 Only) Remote UI (MF6595cx/MF6595/ 7 MF6590/MF6540 Only) System Settings 8 Maintenance 9 Troubleshooting 10 Appendix 11 Cannot receive a document manually. Q Is the machine set to receive manually? A For the machine to receive faxes manually, the receive mode must be set to . (See "Basic Receiving Method," on p. 4-23.) A If you set to in in the menu, the machine will receive faxes automatically even when the receive mode is set to . (See "MANUAL/ AUTO," on p. 11-17. Q Did you hang up the external telephone before pressing [Start] or dialing the remote reception ID? A Always press [Start] or dial the remote reception ID before hanging up. Otherwise you will disconnect the call. Q Are documents set on the ADF? A After removing the document from the ADF, please attempt manual receiving again. If you press [Start] when documents are set on the ADF, it automatically switches to manual sending. Back Previous Next TOP Print quality is poor. Q Is the toner low or unevenly distributed? A Redistribute the toner inside the toner cartridge. If the problem persists, replace the toner cartridge. (See "Replacing the Toner Cartridge," on p. 9-13.) Q Is the correct type of paper loaded in the machine? A Make sure you load paper that meets the requirements for use. (See "Paper Requirements," on p. 2-7.) Q Is the sender's machine functioning properly? A Ask the sender to check that the scanning components of the machine are clean. Q Is the machine in the toner saver mode? A Set to . (See "COMMON SETTINGS," on p. 11-5.) Table of Contents Index 10-28