Cisco III System Message Guide - Page 114

CWSLC Messages Chapter 2 Messages and Recovery Procedures CWRPSPA-3 Error Message %CWRPSPA-3-MAX_SPA: Power to IPSEC-SPA-2G in [chars] is denied because it has exceeded the number allowed([dec]) Explanation The number of IPSEC-SPA-2G port adapters in a chassis is limited. This message displays when the number of IPSEC-SPA-2G port adapters in the chassis has exceeded the limit. Recommended Action Use only the number of supported IPSEC-SPA-2G port adapters. CWRPSPA-4 Error Message %CWRPSPA-4-SPA_CMD_NO_RESP: [chars]: No response for interface configuration command [int] Explanation A timeout occurred while the RP was waiting for a response from the line card. This condition may occur when the line card CPU is too busy to respond to the configuration command. Recommended Action Retry the configuration command. CWRPSPA-6 Error Message %CWRPSPA-6-CARDRELOAD: Module [int] reload due to SPA insert in [int]/[int]. Explanation When inserting a SPA on the specified module, the module resets. Recommended Action This message is informational. No action is required. CWSLC Messages This section contains WAN SiByte Module (CWSLC) messages. CWSLC-3 Error Message %CWSLC-3-DIAGFAIL: Failed to handle diag [chars] [dec] Explanation The module failed to execute a diagnostics command. Recommended Action Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying information. Search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the 2-84 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02