Cisco III System Message Guide - Page 278
SSP-4, SSP-5, SSP-6
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 278 highlights
SSP Messages Chapter 2 Messages and Recovery Procedures SSP-4 SSP-5 SSP-6 Error Message %SSP-4-CANNOTRUNVER: SSP version [dec].[dec] was requested but is not supported in this image. Explanation The version of SSP requested by the active device is not available in this image. SSP will not run on this device until it is upgraded or the active device is downgraded. Recommended Action Verify that all SSP peers are running compatible images and that the configuration on each device is correct. Error Message %SSP-4-GROUPCREATEFAIL: The SSP group could not be created. Explanation The maximum number of SSP groups has been reached. Only one SSP group is permitted at one time. Recommended Action No action is required. Error Message %SSP-4-MISMATCHEDVERRECV: Wrong version on received packet. Explanation The SSP version information in a received packet does not match the version that is currently running on this device. Recommended Action Verify the configuration of all the SSP peers. Ensure that all peers are running the correct image. Error Message %SSP-5-DISABLED: SSP entering disabled state. Explanation The SSP has entered the disabled state. This condition is normal under many circumstances. An example of a normal condition is when the SSP configuration is changed or when a tracked interface is shut down or fails. Recommended Action If this change occurred because of failure on the active peer, eliminate the cause of failure and reload the failed device. Error Message %SSP-6-ACTIVE: SSP entering active state. Explanation The SSP has entered the active state. Recommended Action No action is required. 2-248 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02