Cisco III System Message Guide - Page 235

Chapter 2 Messages and Recovery Procedures PM_SCP Messages Error Message %PM-4-MPLS_MTU_PORT_CFG: MPLS MTU size [dec] is not supported by port [chars]. Explanation The MPLS MTU size that was configured on the port is larger than the maximum MTU size that can be supported by this port. Large packets might be dropped. Recommended Action Reduce the MPLS MTU size. Error Message %PM-4-PORT_BOUNCED: Port [chars] was bounced by [chars]. Explanation During a switchover, the PM needed to perform a reactivation of a port that was in the link-down state. A port is only reactivated when the port data structures lack consistency between the active and redundant supervisor engines. Active ports in the link-down state were returned to the link-up state by the reactivation event. Recommended Action No action is required. PM_SCP Messages This section contains port manager Switch-Module Configuration Protocol (PM_SCP) messages. PM_SCP-1 Error Message %PM_SCP-1-LCP_FW_ERR_POWERDOWN: Module [dec] will be powered down due to firmware error: [chars] Explanation A nonrecoverable error was detected by the switching module firmware and the switching module will be powered down to keep the system functioning. [dec] is the module number and [chars] explains that the system will be powered down. Recommended Action No action is required. PM_SCP-2 Error Message %PM_SCP-2-TRANSCEIVER_INCOMPATIBLE: Transceiver inserted in [chars] port [dec]/[dec] is not compatible with its interface (transceiver speed is [chars], interface speed is [chars]) Explanation An incompatible transceiver was inserted in the specified module. This transceiver should not be used with this module. Recommended Action Replace the specified transceiver with another transceiver that is compatible with this module. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-205