Cisco III System Message Guide - Page 169

Chapter 2 Messages and Recovery Procedures FM Messages Error Message %FM-4-L2EOU_INSP: INSPECTION & L2EOU conflict on i/f [chars] Explanation The inspection feature and the L2EOU feature are not supported on the same VLAN. The inspection feature will be inactive. To activate the inspection feature, reconfigure it after removing the L2EOU feature. Recommended Action Remove either the L2EOU feature or the inspection feature from the interface. Error Message %FM-4-L2EOU_VACL: VACL Capture & L2EOU conflict on i/f [chars] Explanation VACL capture and the L2EOU feature are not supported on the same VLAN port. VACL capture will be inactive. To activate VACL capture, reconfigure the feature after removing the L2EOU feature. Recommended Action Remove either the L2EOU feature or VACL capture on this interface. Error Message %FM-4-PISA-INSP: INSPECION & FPM/NBAR conflict on i/f [chars] Explanation The inspection feature and FPM/NBAR are not supported on the same interface. The inspection feature remains inactive. To activate the inspection feature, reconfigure it after removing FPM/NBAR from the interface. Recommended Action Remove either FPM/NBAR or the inspection feature from this interface. Error Message %FM-4-TCAM_ADJ: Hardware ACL adjacency capacity exceeded Explanation The hardware does not have the capacity to handle all of the configured adjacencies. Recommended Action The configured policies have too many adjacencies to fit in the hardware. Use the mls tcam priority command to prioritize interfaces for hardware switching. Reduce the number of adjacencies in the policies. Error Message %FM-4-TCAM_DYN_ENTRY_EXCEPTION: Failed to install Dynamic TCAM entry in TCAM for Interface:[chars] Explanation Dynamic installation of an ACE failed because of TCAM resource exhaustion. Layer 3 traffic will be handled by the software. Recommended Action Attempt to free up TCAM resources. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-139