Cisco III System Message Guide - Page 94
CONST_V6 Messages, CONST_V6-5
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
CONST_V6 Messages Chapter 2 Messages and Recovery Procedures Error Message %CONST_DIAG-6-HM_TEST_INFO: CPU util(5sec): SP=[dec]% RP=[dec]% Traffic=[dec]% netint_thr_active[[dec]], Tx_Rate[[dec]], Rx_Rate[[dec]] Explanation This message provides system resource information during an event. Recommended Action This message is informational. No action is required. Error Message %CONST_DIAG-6-HM_TEST_SP_INFO: [chars][[dec]]: last_busy_percent[[dec]%], Tx_Rate[[dec]], Rx_Rate[[dec]] Explanation This message displays system resource information during the event Recommended Action This message is informational only. No action is required. Error Message %CONST_DIAG-6-HM_TEST_RECOVERED: Module [dec] [chars] recovered after [dec] consecutive failure(s) Explanation The health-monitoring test recovered from transient failure on the specified module. Recommended Action This message is informational. No action is required. CONST_V6 Messages This section contains IP version 6 (CONST_V6) messages. CONST_V6-5 Error Message %CONST_V6-5-FIB_EXCEP_OFF: Protocol IPv6 recovered from FIB exception Explanation The IPv6 CEF table successfully reloaded to the hardware FIB TCAM. All IPv6 packets will be switched by the hardware. Recommended Action No action is required. Error Message %CONST_V6-5-FIB_EXCEP_ON: Failed to insert an IPv6 prefix in hardware FIB TCAM Explanation The switch failed to insert an IPv6 entry into the hardware FIB TCAM because the total number of software forwarding entries exceeded the hardware FIB TCAM limit. Some IPv6 packets might be switched by the software. Recommended Action Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying information. Search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or 2-64 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02