Cisco III System Message Guide - Page 204

MLS_RATE Messages, MLS_RATE-4

Get Cisco III - Supervisor Engine III PDF manuals and user guides
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals

Page 204 highlights

MLS_RATE Messages Chapter 2 Messages and Recovery Procedures Error Message %MLSM-6-MMLS_NO_EGRESS_LOCAL_IN_INGRESS: MMLS: Egress Local feature is NOT applicable in Ingress mode Explanation When the system transitions from egress replication mode to ingress mode, the egress local feature will not be applied, even if the egress local feature is enabled. Recommended Action If the egress local feature is required, restore the system replication mode to egress. MLS_RATE Messages This section contains Multilayer Switching Rate Limit (MLS_RATE) messages. MLS_RATE-4 Error Message %MLS_RATE-4-CPP_DISABLED_IN_HW: Control Plane Policing NOT performed in hardware, due to the presence of egress QoS. Explanation CPP cannot be performed in the hardware when the system is running in PFC3A mode and egress QoS is configured on any other interface. Under these circumstances, CPP is performed only in the software until egress QoS is removed from the running configuration. Recommended Action Remove any egress QoS from the running configuration, or upgrade to a PFC3B or PFC3-BXL. We strongly recommend the upgrade. Error Message %MLS_RATE-4-CPP_RE_ENABLED_IN_HW: Control Plane Policing will now be performed in hardware. Explanation CPP cannot be performed in the hardware when the system is running in PFC3A mode and egress QoS is configured on any other interface. Egress QoS has been removed from the running configuration. Recommended Action Because egress QoS has been removed, no action is required. To prevent this condition from occurring again, we strongly recommend that you upgrade to a PFC3B or PFC3BXL. Error Message %MLS_RATE-4-DISABLING: The Layer2 Rate Limiters have been disabled. Explanation This feature is turned off with the current hardware configuration. The Layer 2 rate limiters are not supported with this combination of modules. Recommended Action Refer to the feature usage guidelines for more details. 2-174 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290
  • 291
  • 292
  • 293
  • 294
  • 295
  • 296
  • 297
  • 298
  • 299
  • 300
  • 301
  • 302
  • 303
  • 304
  • 305
  • 306
  • 307
  • 308
  • 309
  • 310
  • 311
  • 312
  • 313
  • 314
  • 315
  • 316
  • 317
  • 318
  • 319
  • 320
  • 321
  • 322
  • 323
  • 324
  • 325
  • 326
  • 327
  • 328
  • 329
  • 330
  • 331
  • 332
  • 333
  • 334
  • 335
  • 336
  • 337
  • 338
  • 339
  • 340
  • 341
  • 342
  • 343
  • 344
  • 345
  • 346
  • 347
  • 348
  • 349
  • 350
  • 351
  • 352
  • 353
  • 354
  • 355
  • 356
  • 357
  • 358
  • 359
  • 360
  • 361
  • 362
  • 363
  • 364
  • 365
  • 366
  • 367
  • 368
2-174
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2
Messages and Recovery Procedures
MLS_RATE Messages
Error Message
%MLSM-6-MMLS_NO_EGRESS_LOCAL_IN_INGRESS: MMLS: Egress Local feature is
NOT applicable in Ingress mode
Explanation
When the system transitions from egress replication mode to ingress mode, the egress
local feature will not be applied, even if the egress local feature is enabled.
Recommended Action
If the egress local feature is required, restore the system replication mode to
egress.
MLS_RATE Messages
This section contains Multilayer Switching Rate Limit (MLS_RATE) messages.
MLS_RATE-4
Error Message
%MLS_RATE-4-CPP_DISABLED_IN_HW: Control Plane Policing NOT performed
in hardware, due to the presence of egress QoS.
Explanation
CPP cannot be performed in the hardware when the system is running in PFC3A mode
and egress QoS is configured on any other interface. Under these circumstances, CPP is performed
only in the software until egress QoS is removed from the running configuration.
Recommended Action
Remove any egress QoS from the running configuration, or upgrade to a
PFC3B or PFC3-BXL. We strongly recommend the upgrade.
Error Message
%MLS_RATE-4-CPP_RE_ENABLED_IN_HW: Control Plane Policing will now be
performed in hardware.
Explanation
CPP cannot be performed in the hardware when the system is running in PFC3A mode
and egress QoS is configured on any other interface. Egress QoS has been removed from the running
configuration.
Recommended Action
Because egress QoS has been removed, no action is required. To prevent this
condition from occurring again, we strongly recommend that you upgrade to a PFC3B or PFC3BXL.
Error Message
%MLS_RATE-4-DISABLING: The Layer2 Rate Limiters have been disabled.
Explanation
This feature is turned off with the current hardware configuration. The Layer 2 rate
limiters are not supported with this combination of modules.
Recommended Action
Refer to the feature usage guidelines for more details.