Cisco III System Message Guide - Page 73

Chapter 2 Messages and Recovery Procedures C7600_SSC400 Messages Error Message %C7600_SSC400-3-SINGLE_SPA_MODE: Module will use only bay [dec]. Bay [dec] is shut. Explanation The 7600-SSC-400 is in single-SPA mode. Recommended Action This message is informational only. No action is required. Error Message %C7600_SSC400-3-SSC_BAY_SHUT: Bay [dec] is shutdown because 7600-SSC-400 is in single-spa-mode Explanation The specified bay is shut down. In single-SPA mode, only one bay is active. Recommended Action Refer to the IPsec SPA documentation for information about single-SPA mode. Error Message %C7600_SSC400-3-SW_ERROR: NULL Explanation A software error occurred. Recommended Action Copy the error message exactly as it appears on the console or in the system log. Research and attempt to resolve the error using the Output Interpreter https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Also perform a search of the Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support representative and provide the representative with the gathered information. C7600_SSC400-7 Error Message %C7600_SSC400-7-DP_DISABLE: [chars] FPGA is forced disabled. Explanation This field-programmable gate array (FPGA) has been forced into a disabled state. This is a debugging feature. Recommended Action No action is required. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-43