Cisco III System Message Guide - Page 234
PM Messages, PM-1, PM-4
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 234 highlights
PM Messages Chapter 2 Messages and Recovery Procedures Error Message %PISAL2M-6-NBAR_PD_ACCEL_ENABLED: Protocol Discovery accelerated on [chars] direction of: [chars] Explanation NBAR protocol discovery acceleration is enabled. This traffic will be sent to PISA. Recommended Action No action is required. Error Message %PISAL2M-6-NBAR_TAGGING_DISABLED: NBAR protocol Tagging disabled on [chars] direction of: [chars] Explanation NBAR protocol tagging is disabled. This traffic will not be sent to PISA. Recommended Action No action is required. Error Message %PISAL2M-6-NBAR_TAGGING_ENABLED: NBAR protocol Tagging enabled on [chars] direction of: [chars] Explanation NBAR protocol tagging is enabled. This traffic will be sent to PISA. Recommended Action No action is required. PM Messages This section contains port manager (PM) messages. PM-1 PM-4 Error Message %PM-1-INCONSISTENT_PORT_STATE: Inconsistent HW/SW port state for [chars]. Please shut/no shut the interface Explanation The hardware and software port state has become inconsistent. [chars] is the interface. Recommended Action No action is necessary. This message is for informational purposes only. Error Message %PM-4-MPLS_MTU_EC_CFG: MPLS MTU size [dec] is not supported by one or more ports in channel [chars]. Explanation The MPLS MTU size that was configured on the Ethernet channel is larger than the maximum MTU size that can be supported by one or more ports in this channel. Large packets might be dropped. Recommended Action Reduce the MPLS MTU size, or remove these ports from the channel before increasing the MPLS MTU size. 2-204 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02