Cisco III System Message Guide - Page 269
SMSC_RP-6, SNMP Messages, SNMP-5
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 269 highlights
Chapter 2 Messages and Recovery Procedures SNMP Messages Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support representative and provide the representative with the information you have gathered. Attach the following information to your case in nonzipped, plain-text (.txt) format: the output of the show logging and show tech-support commands and your pertinent troubleshooting logs. Error Message %SMSC_RP-3-SSC_SSPA_SHUT: 7600-SSC-400 in slot [dec] is shutdown because it cannot be set in single-spa-mode Explanation The specified slot has shut down because it could not be set in single-SPA mode. Recommended Action Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying information. Search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support representative and provide the representative with the information you have gathered. Attach the following information to your case in nonzipped, plain-text (.txt) format: the output of the show logging and show tech-support commands and your pertinent troubleshooting logs. SMSC_RP-6 Error Message %SMSC_RP-6-INVALID_HW_VERSION: Single-spa-mode is not allowed for 7600-SSC-400 hardware version [dec].[dec]. Explanation Only 7600-SSC-400 versions greater than 0.3 can be set in single-SPA mode. Recommended Action To use single-SPA mode, use 7600-SSC-400 versions greater than 0.3. SNMP Messages This section contains Simple Network Management Protocol (SNMP) messages. SNMP-5 Error Message %SNMP-5-MODULERESET: [chars] object has been set to 'reset' for [chars]=[dec] from IP address [chars]. Explanation The SNMP server has reset a module. Recommended Action No action is required. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-239