Cisco III System Message Guide - Page 203
MLSM Messages, MLSM-6
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Chapter 2 Messages and Recovery Procedures MLSM Messages MLSM Messages This section contains Multicast Distributed Shortcut Switching (MDSS)/multilayer switching for multicast (MLSM) messages. MLSM-6 Error Message %MLSM-6-MLSM_PMS: MMLS: MLSM is suspending the caller process [chars] Explanation MLSM is suspending the caller process. This message appears when the MLSM routines are called from the PIM/Mwheel context and MLSM routines suspend a process. When MLSM suspends the caller process, data corruption might occur for the data that is handled by the caller process. Recommended Action This message is informational. Error Message %MLSM-6-MMLS_EGRESS_INFO: MMLS: Please make sure no multicast traffic is going through egress incapable line cards when system is operating in egress mode Explanation There should be no multicast traffic going through egress-incapable line cards while the system is operating in egress replication mode. Recommended Action Determine if there are any egress-incapable line cards in the system. If there are egress-incapable line cards, verify that there is no multicast traffic going through them. Error Message %MLSM-6-MMLS_LEGACY_INSERTED: MMLS: Legacy Linecard Inserted, Egress Replication Mode will be disabled Explanation Egress replication is not supported with legacy modules. The system will transition to ingress mode and will cause a temporary loss of traffic. Recommended Action If the system is required to operate in egress replication mode, remove the legacy module. Error Message %MLSM-6-MMLS_MODE_CHANGE: MMLS: Replication Mode Change Detected Explanation When automatic detection of the replication mode is enabled, the system will transition to ingress mode when an egress-incapable module is inserted. The system will transition back to egress mode when the last egress-incapable module is removed. Recommended Action Transitioning between ingress and egress mode causes a temporary loss of traffic. To prevent this temporary loss of traffic, enter the mls ip replication-mode ingress command. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-173