Cisco III System Message Guide - Page 85

Chapter 2 Messages and Recovery Procedures CHKPT Messages CHKPT Messages This section contains checkpointing (CHKPT) messages. CHKPT-3 OL-11469-02 Error Message %CHKPT-3-ILLEGAL: ILLEGAL call to CF API on ([chars]) by ([chars]). Explanation A severe software error occurred with the Checkpoint Facility (CF) application program interface (API). Recommended Action Verify that the system is running released software. If the problem persists, copy the error message exactly as it appears, and report it to your technical support representative. Error Message %CHKPT-3-IPCPORT: Unable to create IPC port on ([chars]). Explanation A severe checkpoint error occurred. The system was unable to allocate the resources needed to create a communications port for the Interprocess Communications (IPC) channel needed to transmit messages. Recommended Action Verify that the system is running released software. If the problem persists, copy the error message exactly as it appears, and report it to your technical support representative. Error Message %CHKPT-3-IPCSESSION: Unable to open an IPC session for communicating with ([chars]). rc= [dec] Explanation A severe checkpoint error occurred. The system was unable to establish an Interprocess Communications (IPC) session between interfaces, which is needed to transmit messages. Recommended Action Verify that the system is running released software. If the problem persists, copy the error message exactly as it appears, and report it to your technical support representative. Error Message %CHKPT-3-NOMEM: Unable allocate resource for CF on ([chars]). Explanation A severe checkpoint error occurred. The system was unable to allocate the necessary resources (typically memory) on the indicated interface to create an Interprocess Communications (IPC) channel for transmitting messages. Recommended Action Verify that the system is running released software. If the problem persists, copy the error message exactly as it appears, and report it to your technical support representative. Error Message %CHKPT-3-RFREG: Unable to register checkpoint as client of RF. Explanation A severe checkpoint error occurred. The system was unable to register with the redundancy facility (RF) so that it could begin the transmission of IPC messages between interfaces. Recommended Action Verify that the system is running released software. If the problem persists, copy the error message exactly as it appears, and report it to your technical support representative. Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-55