Cisco III System Message Guide - Page 50

C6KENV Messages Chapter 2 Messages and Recovery Procedures Error Message %C6KENV-2-BADFLOWCTRL_WARN: WARNING: Module [dec] not at an appropriate hardware revision level to support DFC3 Explanation The fabric-capable module in the specified slot is not at an appropriate hardware revision level to support a DFC3 or higher. Recommended Action When you upgrade the DFC daughter card, also upgrade the module to an appropriate hardware revision level. Error Message %C6KENV-2-BADPINN1: Module [dec] not at an appropriate hardware revision level to coexist with PFC3 system. Power denied Explanation The module specified in the error message has a revision of 2.x or below. Modules with this revision will experience problems when they are used with a supervisor engine with a PFC3 installed and they should not be used. Recommended Action Upgrade the module to an appropriate hardware revision level. Error Message %C6KENV-2-BADTRANSCEIVER: Module [dec] will be power disabled because an inappropriate transceiver is inserted at [chars]. Explanation An incompatible transceiver is inserted at the interface specified in the error message. This transceiver should not be used in this system. Recommended Action Remove the specified transceiver and restore power to the module. If this transceiver was purchased from Cisco, contact your Cisco technical support representative to get the transceiver replaced. Error Message %C6KENV-2-C2PLUSWITHNODB: The constellation 2 plus module in slot [dec] has no forwarding daughter board. Power denied Explanation The module in the slot specified has no forwarding daughter card and is expected to have either a distributed, accelerated, or centralized forwarding card. This module will not be activated and will remain powered down. Recommended Action Enter the show module command to view error message details. Error Message %C6KENV-2-DFCMISMATCH: Module [dec] DFC incompatible with Supervisor DFC. Power denied Explanation The DFC in the specified module is different from the DFC in the supervisor engine. The module will not be activated and remains powered down. Recommended Action Enter the show module command to view the difference between the DFC in the module and the DFC in the supervisor engine. Error Message %C6KENV-2-DFCMISMATCHMINOR: Module [dec] DFC installed is incompatible with system operating mode. Power denied. To enable Module [dec] DFC, the system must be reset. 2-20 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02