Cisco III System Message Guide - Page 133
Diag-4, Diag-6
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Chapter 2 Messages and Recovery Procedures DIAG Messages DIAG-4 DIAG-6 Error Message %DIAG-4-CONFIG_REAPPLY: Please reapply config command [chars] after the card is online. Explanation This message appears when the specified configuration command cannot be applied. [chars] is the configuration command that you must reapply. Recommended Action The system is working properly and the specified command cannot be applied. Reapply the configuration command after the module is online. Error Message %DIAG-6-SCHEDULE_IS_REMOVED: [chars]: Schedule Diagnostic for [[chars] [chars] [dec]:[dec].] is removed Explanation The scheduled online diagnostics test was removed because the test is no longer applicable. Recommended Action No action is required. The system is working properly. Error Message %DIAG-6-SIMULATED_TEST_RESULT: [chars]: [chars] test result is simulated. Explanation The result of the specified test is simulated. The message does not indicate a software or hardware fault. The first [chars] is the message notification and the second [chars] is the test name. Recommended Action No action is required. The test failure is simulated as specified by the user. Error Message %DIAG-6-SKIP_ONDEMAND_ACTIVE_TO_STANDBY_TEST: [chars]: [chars] cannot be executed. Explanation The diagnostics test is bypassing the specified redundant test because the redundant test cannot be executed. Recommended Action No action is required. The system is working properly. Error Message %DIAG-6-TEST_SKIPPED_FROM_ACTIVE: [chars]: [chars] cannot be executed from active supervisor. Explanation The specified test cannot be run from the active supervisor engine. Recommended Action No action is required. The test cannot be run, but the system is working properly. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-103