Cisco III System Message Guide - Page 178

IDBMAN Messages Chapter 2 Messages and Recovery Procedures Error Message %HYPERION-5-BUS_SEQ_ERR: Constellation bus Sequence Error. Resetting Hyperion ASIC. Explanation The switch processor has detected a sequence error on the backplane bus. A reset sequence from the EARL has been called to recover from this error. System traffic should recover and continue normally. Recommended Action If traffic recovers, no action is required. If traffic does not recover, copy the error message exactly as it appears on the console or in the system log. Enter the show platform hardware hyperion all command to gather data that may help identify the nature of the error. If you cannot determine the nature of the error from the error message text or from the show platform hardware hyperion all output, contact your Cisco technical support representative, and provide the representative with the gathered information. Error Message %HYPERION-5-HYP_INIT_FAILURE: The Hyperion ASIC initialization failed Explanation The Hyperion ASIC initialization was not successful. Recommended Action The Hyperion ASIC is not operational and is disabled. Error Message %HYPERION-5-NULL_HYP_OBJECT: The Hyperion device object pointer is set to NULL Explanation The memory location of the Hyperion ASIC device object is invalid. Recommended Action The Hyperion ASIC operation is disabled, and the device interrupt is now masked. IDBMAN Messages This section contains Interface Descriptor Block Manager (IDBMAN) messages. IDBMAN-4 Error Message %IDBMAN-4-CONFIG_WRITE_FAIL: FFailed to generate confgiruation for interface [chars] Explanation The system failed to generate a configuration for the specified interface because of a problem with the file system. The active and standby supervisor engines will have configurations that do not match. Recommended Action The standby supervisor engine is reloaded automatically to recover from the problem. If the standby supervisor engine does not recover, copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying information. Search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support representative and provide the representative with the 2-148 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02