Cisco III System Message Guide - Page 41
C6K_MPLS_LC Messages, C6K_MPLS_LC-3
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Chapter 2 Messages and Recovery Procedures C6K_MPLS_LC Messages Error Message %C6K_MPLS_COMMON-3-L3_CONFIG_NOT_RECOMMENDED: LAN interfaces are facing the MPLS Core. Do not configure xconnect on interface vlans. Explanation An attempt was made to configure a cross-connection service on an interface VLAN. The current network configuration has MPLS configured on a LAN interface that is facing the MPLS core. Recommended Action Do not configure cross-connection services on an interface VLAN if the network has MPLS configured on a LAN interface. Error Message %C6K_MPLS_COMMON-3-OSM_BB1_CONFIG_UNSUPPORTED: The maximum label range configured for this system exceeds the [int] limit supported by the module in slot [int]. For proper MPLS functionality on any of the interfaces on this module the maximum label range should be set to [int]. Explanation The OSM cannot support the MPLS label range configured for this system. Recommended Action Change the maximum MPLS label range by using the mpls label range command. Error Message %C6K_MPLS_COMMON-3-VPLS_CONFIG_EXCEEDED: The number of EoMPLS/VPLS VCs exceeded the maximum supported on [IP_address]/[int]. Explanation The number of destination routers or the global number of virtual circuits exceeded the maximum limit supported by the device. Recommended Action Refer to network configuration guidelines for the maximum limits. C6K_MPLS_LC Messages This section contains Catalyst 6500 series switch and Cisco 7600 series router Multiprotocol Label Switching (MPLS) switch processor or module (C6K_MPLS_LC) messages. C6K_MPLS_LC-3 Error Message %C6K_MPLS_LC-3-MALLOCFAIL: failed to create [chars] Explanation The system failed to allocate memory for an MPLS entry for the incoming label. Some MPLS packets might be forwarded by the software. Recommended Action Reduce other system activity to ease memory demands. If necessary, increase system memory. When more memory is available, wait for a few minutes and enter the clear ip route command. If sufficient memory has not been made available, this message will be displayed again. If this problem persists, contact your Cisco technical support representative. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-11