Cisco III System Message Guide - Page 277

Chapter 2 Messages and Recovery Procedures SSP Messages information you have gathered. Attach the following information to your case in nonzipped, plain-text (.txt) format: the output of the show logging and show tech-support commands and your pertinent troubleshooting logs. SSP Messages This section contains State Synchronization Protocol Manager (SSP) messages. SSP-3 Error Message %SSP-3-DATACREATEFAIL: Creation of required data structures failed. Explanation The SSP will not operate properly due to the abnormal initialization of required data structures. Recommended Action Reload the device. If the error persists, contact your technical service representative. Error Message %SSP-3-EXCEEDMAXDOI: SSP maximum DOI exceeded. Explanation The configuration has exceeded the maximum number of SSP clients allowed on this device at any one time. Recommended Action Verify your configuration and reduce the number of SSP clients running at the same time. If a large number of SSP clients is required, contact your technical service representative for assistance. Error Message %SSP-3-NOSTART: SSP could not initialize. Explanation The SSP process could not successfully initialize. This condition might be caused by unusual protocol startup times in certain topologies. Recommended Action Ensure that your IP redundancy mechanism (HSRP) configuration is valid and that all protocols have started. Try to configure SSP again. If this error recurs, contact your technical support representative. Error Message %SSP-3-SRVSOCKCREATEFAIL: SSP socket creation failed. Explanation The SSP process could not establish a socket connection with the SSP peer. This condition is likely to occur because either the device is under extreme load or it is misconfigured. Recommended Action Verify that the SSP configuration is valid. Configure SSP to use a different port number. Reduce the load on the device. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-247