Cisco III System Message Guide - Page 45

Chapter 2 Messages and Recovery Procedures C6K_PLATFORM Messages information you have gathered. Attach the following information to your case in nonzipped, plain-text (.txt) format: the output of the show logging and show tech-support commands and your pertinent troubleshooting logs. C6K_PLATFORM-4 Error Message %C6K_PLATFORM-4-CONFREG_BREAK_ENABLED : The default factory setting for config register is 0x2102.It is advisable to retain 1 in 0x2102 as it prevents returning to ROMMON when break is issued. Explanation The SP configuration register has been changed from the default factory setting of 0x2102 to another hexadecimal value. Recommended Action No action is required. Error Message %C6K_PLATFORM-4-ENVMON: System shutdown due to temperature alarms is [chars]. Explanation The system has a configuration to shut down a module if its operating temperature exceeds a temperature threshold. This configuration has been bypassed, and a module will still operate in an over-temperature condition. Operating at an over-temperature condition can damage the hardware. Recommended Action Do not override the sensor alarms that act on an over-temperature condition. Enter the environment-monitor shutdown temperature command to bring the system back to standard temperature detection. Error Message %C6K_PLATFORM-4-RTC_OSCILLATOR: The oscillator in the Real Time Clock is [chars]. Calendar [chars] be maintained during the powered down state of the switch. Explanation A command has been entered that will cause the system calendar not to be maintained during a power down of the switch. The system date and time will require manual setting when the system is powered up during the next boot time. This command is useful to conserve the battery power of the CMOS, which is used to keep the real-time clock active while the switch is powered down. This condition is useful only if the switch is powered down for a long period of time. Recommended Action If the switch need not be powered down for a long period of time, remove the configuration by entering the no hw-module rtc-oscillator shutdown command. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-15