Cisco III System Message Guide - Page 279
STAPL Messages, STAPL-4
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 279 highlights
Chapter 2 Messages and Recovery Procedures STAPL Messages Error Message %SSP-6-IPREDGRPADD: An IP Redundancy group listed in the SSP config has been added to this device. Explanation The device might now become the active device or the redundant device if no other configuration items are missing. Recommended Action No action is required. Error Message %SSP-6-IPREDGRPDEL: An IP Redundancy group listed in the SSP config has been removed from this device. Explanation The device might not become the active device or the redundant device if any configuration items are missing. Recommended Action Add the IP redundancy group to the device, or remove it from the SSP configuration. Error Message %SSP-6-STANDBY: SSP entering standby state. Explanation The SSP has entered standby state. Recommended Action No action is required. STAPL Messages This section contains Standard Test and Programming Language (STAPL) messages. STAPL-4 Error Message %STAPL_OPEN-4-ERROR_ALLOC: %Error: Can't allocate [dec] bytes for STAPL data Explanation The system could not allocate the required memory to access the file. Recommended Action Check the memory usage of the system, and retry the operation. Error Message %STAPL_OPEN-4-ERROR_OPEN: %Error: Can't open [chars] Explanation The system is unable to open the file specified in the error message. Recommended Action Ensure that the filename is correct. Enter the dir command to verify the filename. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-249