Cisco III System Message Guide - Page 65
representative and provide the representative with the output of
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Chapter 2 Messages and Recovery Procedures C7600_SIP200_SPITX Messages OL-11469-02 Error Message %C7600_SIP200_SPITX-3-EFCEVNT_ERR: [chars] Explanation The egress data path device on the line card detected an error while processing internal extended flow-control events. This condition could cause a reduced packet rate. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. Error Message %C7600_SIP200_SPITX-3-EFC_QUEUE_STUCK: [chars] Explanation The egress data path device on the line card detected an error condition with the extended flow control bus interface. This condition could cause packets to drop. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. Error Message %C7600_SIP200_SPITX-3-EFCSTAT_FAIL_SPA0: [chars] Explanation The egress SPI4.2 device on the line card detected an EFC status clock or synchronization failure. This condition could cause packets to drop. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. Error Message %C7600_SIP200_SPITX-3-EFCSTAT_FAIL_SPA1: [chars] Explanation The egress SPI4.2 device on the line card detected an EFC status clock or synchronization failure. This condition could cause packets to drop. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-35