Cisco III System Message Guide - Page 209
MMLS_RATE Messages, MMLS_RATE-3, MRIB_PROXY Messages, MRIB_PROXY-2
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 209 highlights
Chapter 2 Messages and Recovery Procedures MMLS_RATE Messages Error Message %MMLS-6-VLAN_ADD_FAILURE_ON_MET_FULL: Error adding vlan [dec] to the MET table of some shortcuts Explanation The MET is full. The system is unable to add the specified VLAN to some shortcuts. The affected shortcuts will not switch traffic for that VLAN. Recommended Action The MET utilization is very high and needs to be brought down by removing some VLANs or switching to ingress replication mode. MMLS_RATE Messages This section contains Multicast Multilayer Switching Rate Limiting (MMLS_RATE) messages. MMLS_RATE-3 Error Message %MMLS_RATE-3-MMLS_PARTIAL_SC_ERROR: Error installing Multicast Partial-sc rate-limiter.Operation failed. Explanation The multicast partial-sc rate limiter could not be configured because of an error that was returned from the switch processor. Recommended Action The LTL index for the partial-sc rate limiter might not have initialized yet. Wait several minutes, and try to configure the rate limiter again. MRIB_PROXY Messages This section contains Multicast Routing Information Base proxy (MRIB_PROXY) messages. MRIB_PROXY-2 Error Message %MRIB_PROXY-2-MRIB_LC_CREPRC_FAILED: LC in slot [dec] failed to create a required process. Explanation The line card could not create a process to perform delayed IPC initialization. The MFIB will not be started on this line card. Recommended Action Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying information. Search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support representative and provide the representative with the information you have gathered. Attach the following information to your case in nonzipped, plain-text (.txt) format: the output of the show logging and show tech-support commands and your pertinent troubleshooting logs. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-179