Cisco III System Message Guide - Page 60

C7600_SIP200_SPIRX Messages Chapter 2 Messages and Recovery Procedures Error Message %C7600_SIP200_SPIRX-3-SPA_INTERRUPT: SPA [int] - [chars], SPA Int status = [hex] Explanation A SPA interrupt from the ingress SPI4.2 device has occurred. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. Error Message %C7600_SIP200_SPIRX-3-SPI4_LINKERROR: SPA Bay [int], [int] SPI4 Link Failures Explanation Link errors from the ingress SPI4.2 device have occurred. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. Error Message %C7600_SIP200_SPIRX-3-SRAM_ERROR_DATA: SRAM[dec] Address = [hex][hex] Data = [hex][hex][hex]_[hex][hex][hex]_[hex][hex][hex]_[hex][hex] [hex] Explanation An SRAM address and data dump has occurred. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. Error Message %C7600_SIP200_SPIRX-3-SRAM_INTERRUPT: [chars], Sram Int status = [hex] Explanation An SRAM interrupt has occurred from the ingress SPI4.2 device. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. 2-30 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02