Cisco III System Message Guide - Page 270

SPA_CHOC_DSX Messages Chapter 2 Messages and Recovery Procedures SPA_CHOC_DSX Messages This section contains common channelized Shared Port Adapter (SPA_CHOC_DSX) messages. SPA_CHOC_DSX-3 Error Message %SPA_CHOC_DSX-3-SEMAHOG: SPA on [chars]: Semaphore Hog was encountered. Explanation One process has failed to release the semaphore used by IPC communication between the host and the SPA. This behavior might cause other processes to fail to send commands down to the SPA. This condition might cause improper operation. Recommended Action Stop all traffic on the SPA and then reload the configuration by entering the shut/no shut command on the controllers. If the problem persists, power cycle the SPA. Error Message %SPA_CHOC_DSX-3-SPA_SW_ERR: SPA on [chars]: [chars] Software error was encountered. Explanation The SPA driver detected a software error on the SPA. This condition might result in improper operation. Recommended Action Reload the configuration by entering the shut/no shut command on the controllers. If the problem persists, power cycle the SPA. Error Message %SPA_CHOC_DSX-3-SPI4_HW_ERR: SPA on [chars]: [chars] Hardware error was encountered. Explanation The SPA driver detected a hardware error on the SPA. This condition might result in improper operation. Recommended Action Power down and reseat the indicated SPA line card. SPA_T3E3 Messages This section contains T3E3 (SPA_T3E3) messages. 2-240 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02