Cisco III System Message Guide - Page 62
or contact your Cisco technical support, assistance
UPC - 746320181691
View all Cisco III manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
C7600_SIP200_SPITX Messages Chapter 2 Messages and Recovery Procedures Error Message %C7600_SIP200_SPITX-3-CHANNEL_ENABLE_FAIL: SPI4 Channel [int] for Bay [int], [chars] Failed Explanation The specified SPI4 channel could not be enabled or disabled. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. Error Message %C7600_SIP200_SPITX-3-DESCR_ERR_SPA0: SPAstatus=[hex], syndrome=[hex], RdRspOvf=[int], RdRspTo=[int], OvfVal=[int], OvfCh=[int], OvfDescHi=[hex], OvfDescLo=[hex], DisChk=[int], SeqErrVal=[int], SeqErrCh=[int] Explanation The egress SPI4.2 device on the line card detected a sequence or FIFO overflow error while processing a TX descriptor. This condition could cause packets to drop. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. Error Message %C7600_SIP200_SPITX-3-DESCR_ERR_SPA1: SPAstatus=[hex], syndrome=[hex], RdRspOvf=[int], RdRspTo=[int], OvfVal=[int], OvfCh=[int], OvfDescHi=[hex], OvfDescLo=[hex], DisChk=[int], SeqErrVal=[int], SeqErrCh=[int] Explanation The egress SPI4.2 device on the line card detected a sequence or FIFO overflow error while processing a TX descriptor. This condition could cause packets to drop. Recommended Action If this problem recurs, search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/ under Product cat6000. If you still require assistance, open a case with the Technical Assistance Center via the Internet http://tools.cisco.com/ServiceRequestTool/create or contact your Cisco technical support representative and provide the representative with the output of the show tech-support command for the line card and the show platform hardware spi4 spa-id efc channel [channel-id] command for the SPA. 2-32 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02