Cisco III System Message Guide - Page 236

POSLC Messages Chapter 2 Messages and Recovery Procedures PM_SCP-4 Error Message %PM_SCP-4-FPOE_INFO: An unsupported distributed fabric card has been detected Explanation Fabric-capable modules are not supported in this system. Recommended Action Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying information. Search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support representative and provide the representative with the information you have gathered. Attach the following information to your case in nonzipped, plain-text (.txt) format: the output of the show logging and show tech-support commands and your pertinent troubleshooting logs. Error Message %PM_SCP-4-UNSUPPORTED: Interface [chars] does not support receive-only transceivers Explanation A receive-only transceiver has been inserted into a slot that does not support it. Recommended Action Use the receive-only transceiver with a supported module. POSLC Messages This section contains Packet over SONET module (POSLC) messages. POSLC-3 Error Message %POSLC-3-PROCESS_CREATEFAIL: [chars] Explanation The PoS module could not create a process required for its operation. This condition might occur because a resource is unavailable. Recommended Action Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying information. Search for resolved software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support representative and provide the representative with the information you have gathered. Attach the following information to your case in nonzipped, plain-text (.txt) format: the output of the show logging and show tech-support commands and your pertinent troubleshooting logs. 2-206 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY OL-11469-02