Cisco III System Message Guide - Page 51

C6KENV-4, show module, show platform earl-mode, no environment-monitor shutdown

Page 51 highlights

Chapter 2 Messages and Recovery Procedures C6KENV Messages WARNING: Any system reset will change the system operating mode which can result in degradation of system performance. To eliminate this from occurring, remove Module [dec] DFC or replace with a system compatible DFC. Explanation The DFC in the specified slot does not have the same software operating mode as the rest of the system. The DFC will remain powered down and cannot be activated. Recommended Action Enter the show module and show platform earl-mode commands to view the difference between the DFC in the specified slot and the operating mode of the rest of the system. Error Message %C6KENV-2-FANUPGREQ: Module [dec] not supported without fan upgrade Explanation The supervisor engine and the DFC in the specified slot require a fan tray upgrade. A system shutdown is scheduled. Recommended Action Upgrade the system fan tray. Error Message %C6KENV-2-SHUTDOWN_NOT_SCHEDULED: Major sensor alarm for [chars] is ignored, [chars] will not be shutdown. Explanation The system detected that the specified module should be shut down because it exceeded major sensor thresholds. However, the command that shuts down the module in the event of a major sensor alarm has been overridden, so the specified module will not be shut down. The command used to override the shutdown is no environment-monitor shutdown. Recommended Action Remove the configuration that bypasses the module shutdown due to sensor thresholds being exceeded. Shut down the module after removing the configuration. C6KENV-4 Error Message %C6KENV-4-ALARMCLR: [chars] alarm cleared Explanation The specified alarm condition has been cleared. The shutdown has been cancelled. Recommended Action No action is required. Error Message %C6KENV-4-FANCOUNTFAILED: Required number of fan trays is not present Explanation The system is missing the number of required fan trays to operate properly. Although this is a minor alarm, system components could overheat and be shut down. Recommended Action Insert the required fan tray as soon as possible. Error Message %C6KENV-4-FANCOUNTOK: Required number of fan trays is present Explanation The number of required fan trays has been restored. Recommended Action No action is required. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290
  • 291
  • 292
  • 293
  • 294
  • 295
  • 296
  • 297
  • 298
  • 299
  • 300
  • 301
  • 302
  • 303
  • 304
  • 305
  • 306
  • 307
  • 308
  • 309
  • 310
  • 311
  • 312
  • 313
  • 314
  • 315
  • 316
  • 317
  • 318
  • 319
  • 320
  • 321
  • 322
  • 323
  • 324
  • 325
  • 326
  • 327
  • 328
  • 329
  • 330
  • 331
  • 332
  • 333
  • 334
  • 335
  • 336
  • 337
  • 338
  • 339
  • 340
  • 341
  • 342
  • 343
  • 344
  • 345
  • 346
  • 347
  • 348
  • 349
  • 350
  • 351
  • 352
  • 353
  • 354
  • 355
  • 356
  • 357
  • 358
  • 359
  • 360
  • 361
  • 362
  • 363
  • 364
  • 365
  • 366
  • 367
  • 368

2-21
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2
Messages and Recovery Procedures
C6KENV Messages
WARNING: Any system reset will change the system operating mode which can result
in degradation of system performance. To eliminate this from occurring, remove
Module [dec] DFC or replace with a system compatible DFC.
Explanation
The DFC in the specified slot does not have the same software operating mode as the
rest of the system. The DFC will remain powered down and cannot be activated.
Recommended Action
Enter the
show module
and
show platform earl-mode
commands to view the
difference between the DFC in the specified slot and the operating mode of the rest of the system.
Error Message
%C6KENV-2-FANUPGREQ: Module [dec] not supported without fan upgrade
Explanation
The supervisor engine and the DFC in the specified slot require a fan tray upgrade. A
system shutdown is scheduled.
Recommended Action
Upgrade the system fan tray.
Error Message
%C6KENV-2-SHUTDOWN_NOT_SCHEDULED: Major sensor alarm for [chars] is
ignored, [chars] will not be shutdown.
Explanation
The system detected that the specified module should be shut down because it exceeded
major sensor thresholds. However, the command that shuts down the module in the event of a major
sensor alarm has been overridden, so the specified module will not be shut down. The command used
to override the shutdown is
no environment-monitor shutdown
.
Recommended Action
Remove the configuration that bypasses the module shutdown due to sensor
thresholds being exceeded. Shut down the module after removing the configuration.
C6KENV-4
Error Message
%C6KENV-4-ALARMCLR: [chars] alarm cleared
Explanation
The specified alarm condition has been cleared. The shutdown has been cancelled.
Recommended Action
No action is required.
Error Message
%C6KENV-4-FANCOUNTFAILED: Required number of fan trays is not present
Explanation
The system is missing the number of required fan trays to operate properly. Although
this is a minor alarm, system components could overheat and be shut down.
Recommended Action
Insert the required fan tray as soon as possible.
Error Message
%C6KENV-4-FANCOUNTOK: Required number of fan trays is present
Explanation
The number of required fan trays has been restored.
Recommended Action
No action is required.