Dell PowerConnect 6248 User's Guide - Page 150

Viewing the ARP Table Using CLI Commands For information about the CLI commands that perform this function, see the IP Addressing Commands chapter in the CLI Reference Guide. The following table summarizes the equivalent CLI commands you use. Table 6-19. ARP Table Commands CLI Command show arp switch Description Use to display the entries in the ARP table. IPv6 Management Features The PowerConnect 6200 Series switch software includes several enhancements to the IPv6 management feature. You can assign either an IPv4 or IPv6 address to the management interface. In previous software releases, the management port supported IPv6 addresses, but only when the switch received its IPv6 addressing and gateway definitions through auto-configuration when connected to an IPv6 router on the management network. Support for host name mapping to a host with an IPv6 address is also present. To display the IPv6 Management Interface page, click System →IP Addressing →IPv6 Address Management in the tree view. Figure 6-30. IPv6 Address Management The IPv6 Address Management page contains the following fields: • IPv6 Mode -Enables or disables IPv6 mode on the management interface. • Network Configuration Protocol - Specify whether to use DHCP for dynamic IPv6 address assignment. If you select None, you can configure a static IPv6 address. 150 Configuring System Information