Dell PowerConnect 6248 User's Guide - Page 667

• Tag - Sets the tag field in routes redistributed. This field displays the tag if the source was preconfigured, otherwise 0 is displayed. Valid values are 0 to 4294967295. • Redistribute - Enables or disables the redistribution for the selected source protocol. This field has to be enabled in order to be able to configure any of the route redistribution attributes. Configuring OSPFv3 Route Redistribution 1. Open the OSPFv3 Route Redistribution Configuration page. 2. Specify Create to set up a new configured source. Specify Connected or Static to modify an existing configured source. 3. Set up or modify the remaining fields as needed. 4. Click Apply Changes. The selected route redistribution is configured for OSPFv3, and the device is updated. Configuring OSPFv3 Route Redistribution Using CLI Commands For information about the CLI commands that perform this function, see the following chapter in the CLI Reference Guide: • OSPFv3 Commands The following table summarizes the equivalent CLI commands for this feature. Table 10-24. OSPFv3 Route Redistribution Commands CLI Command redistribute distribute-list out Description Configures the OSPFv3 protocol to allow redistribution of routes from the specified source protocol/routers. Specifies the access list to filter routes received from the source protocol. OSPFv3 Route Redistribution Summary Use the OSPFv3 Route Redistribution Summary page to display route redistribution settings by source. To display the page, click IPv6 →OSPFv3 →Route Redistribution Summary in the tree view. Configuring IPv6 667