Dell PowerConnect 6248 User's Guide - Page 248

- Disable - Uses the configuration file as the running configuration only. When the switch reboots, it will load the configuration from the startup configuration file. • Retry Count - Indicates the number of times to attempt the auto configuration process during boot up. The number of times the switch has attempted to contact the TFTP server during the current Auto Configuration session. • Auto Configuration State - Shows the current state of the Auto Configuration process. Configuring Auto Configuration Using CLI Commands For information about the CLI commands that perform this function, see the Utility Commands - Auto Config chapter in the CLI Reference Guide. The following table summarizes the equivalent CLI commands you use to configure Auto Configuring. Table 6-52. Auto Configuration Commands CLI Command boot host auto-save boot host dhcp boot host retry-count show boot Description Enables/disables automatically saving the downloaded configuration on the switch. Enables/disables Auto Config on the switch. Set the number of attempts to download a configuration. Displays the current status of the Auto Config process. 248 Configuring System Information